Installating Hyper-v in Windows Server2008 Core

First of all, you can not carry out the following command-line virtual machine creation and management. So in your server in the Server Core install Hyper-V, you need to use another one with Hyper-V management interface, Windows 2008 Server or Hyper-V Manager have installed Vista SP1 a good machine and to create Virtual Machine Management.
Second, let me illustrate how Server Core installation mode, Hyper-V, installed in two steps:

1. First of all, you need to use Server Core to start bcdedit to change the configuration, you run the following command:

bcdedit / set hypervisorlaunchtype auto

NOTE: If you did not configure this setting, when you run more than one order, Server Core to restart.

2. Then please use the following command to install the Hyper-V

start / w OCSetup Microsoft-Hyper-V

Such as the end of the command, you restart this Server Core to complete the installation, because Hyper-V need to restart to complete installation. Then you use the command oclist to see is not the role of the Hyper-V has been installed.

Finally, I want to say is how to encourage good equipment outside the Hyper-V server management, you need to do in Server Core on a number of additional operation.

a. In the Server Core to enable remote management, please use the following order:

netsh advfirewall firewall set rule group = "Remote Administration" new enable = yes

b. in the following order of the opening of the Remote Desktop

cscript \ windows \ system32 \ scregedit.wsf / ar 0
cscript \ windows \ system32 \ scregedit.wsf / cs 0

c. use the following command to restart the Server Core configuration of these machines to allow the entry into force

shutdown / t 0 / r